Solar Tracker Using Arduino And Servo Motor

To track the sun i used four ldc sensors and arduino compares the data from them to rotate the panel in the direction with the most sunlight using two dc motors one for each axis and motor driver.

Solar tracker using arduino and servo motor.

If you are simply trying this project for fun then a breadboard is perfect. 5 to 12 volt power supply. The sensors are connected in series with 10 k ohm resistors. Ldr 2 nos.

Four ldrs and four 100kω resistors are connected in a voltage divider fashion and the output is given to 4 analog input pins of arduino. This solar tracker uses two ldrs to measure the light or the resistance of the ldr changes according to the light. Interfacing dual axis solar tracker arduino project using ldr servo motors. Before reading the post please check the video from my channel it gives 70 of idea about the project.

The circuit design of solar tracker is simple but setting up the system must be done carefully. Tact switch button resistors 10k 3 nos. It can also charge mobile phone. 3 two wires for supply and one wire for pwm to control its positions.

In this project an arduino nano is used which works as a controlling unit. The pwm inputs of two servos are given from digital pins 9 and 10 of arduino. Since ldr is an analogue sensor they are connected to the analog pins a0 and a1 of arduino. This solar tracker system uses the arduino uno board a servomotor 2 ldrs and 2 resistors to rotate the solar panel towards the sun or a source of light.

The circuit diagram for the arduino based solar tracker using ldr servo motor is given below. Photovoltaic powers the solar tracker no external source needed. If you are going to be installing the solar tracker permanently then you may want to solder the resistors and ldrs together so that they cannot come loose. So i ve made a solar tracker using an arduino and servo motor.

The embedded software design the embedded software is the piece that will be embedded in the hardware arduino uno to control and monitor the solar tracker test bench. Arduino solar tracker with servomotor. Similarly connect the gnd pin from the arduino to a second lower horizontal row of the breadboard. Following are the list of components required to design a solar tracker.

The servo is controlled through one of the arduino s pwm outputs. Read servo motor control using arduino in the circuit two ldr light dependent resistors sensors are used to sense the light. The used servo motors are controlled by the arduino uno board via 3 wire electrical cable as shown in fig. A dummy solar plate is attached in parallel to the axis of servo motor and both the sensors are kept on the dummy solar plate as shown in the figure below.